Conveyor Pull Cord Switches
Emergency stop switches stop the conveyor electrically at any point along the conveyor.
- Heavy duty pulling mechanism compensates for temperature drifts, preventing false trips.
- Electrical rotary switch allows the switch to be tripped manually. The electrical switch is a self-wiping rotary switch (not a microswitch), and consists of two normally open and two normally closed contacts.
- Switch knob is padlockable in the "Off" position. Once the switch has been tripped, the knob latches in the "Off" position and must be manually reset in order to restart the conveyor.
- High impact U.V. stabilized polycarbonate enclosure is rated IP 66 and D.I.P. (Dust Ignition Proof) degree of protection.
- Recommended distance between switches is 330 feet (100.6 m).
- Approved for use in non-hazardous locations by the Pennsylvania Dept. of Environmental Resources Mine Safety and Health Administration (MSHA).
Standard Pull Cord Switch
- All the standard features listed above.
- Self-wiping rotary switch (not a microswitch).
- Isolated mechanical and electrical sections.
- Heavy duty pulling mechanism eliminates false trips.
- Mounted on 330' (100.6 m) intervals.
- Corrosion-proof construction.
- For non-hazardous locations.
- For hazardous locations, must be installed in an intrinsically safe circuit.
Part Number: CTS 100
Pull Cord Switch with Trip Light
- Standard switch features.
- Trip indicator light rated at 15W for locating the tripped switch.
- For use in a non-hazardous locations only.
Part Number: CTS 200L
Intrinsically Safe Pull Cord Switch
- Standard switch features.
- Trip indication LEDs.
- Hazardous and non-hazardous locations.
Part Number: CTS 300
Intrinsically Safe Switch with Pre-Start Alarm
- Standard switch features.
- Audible and visible pre-start alarms.
- Trip indication LEDs.
- Hazardous and non-hazardous locations.
Part Number: CTS 300 PSW
Home
Products
Shop
Cart
Contact